Used for 3D measurements such as laser trackers and photogrammetry, these holders provide accurate cost effective holders for SMRs.

This range of SMR targetholders is available for use with 1.5, 0.875 and 0.5in SMRs (CCRs), including:

• magnetic, flat back drift nests for use as temporary targets on almost any surface
• shank mounts, for mounting in selection of hole diameters
• ‘Diamond shank’ mounts for use with slotted bushings
• corner adaptors and edge detectors
• permanent floor and reference mounts
• 1.5in (38mm) adaptors to accurately hold smaller SMRs (CCRs)

A separate catalogue is available on request.