News: General News
15th September 2016
An easy way to view the full dimensional metrology range in one virtual showroom:
8th July 2021 • Read »
Peen marking/engraving for parts identification is a critical element in industries such as aviation, defence and medical
7th September 2020 • Read »
Shipbuilders around the world are currently facing the challenge of reducing their environmental impact. The alignment telescope is used for accurate alignment of engines, propeller shafting and stern tubes - reducing vibration and wear which cause fuel inefficiencies.
23rd April 2020 • Read »
Watch our short video to see how this handheld gauge and 3D analysis software measures chamfer, edge rounding and edge break at high speed.
16th April 2020 • Read »
Spectrum Metrology is pleased to introduce a ground-breaking handheld gauging system to the MRO Europe exhibition for rapid micro-defect/corrosion analysis directly on the shopfloor. The 4D INSPEC Â® inspection gauge is a completely new method of reliably measuring micro-defects in 3D such as scratches nicks, pits, protrusions, radius of curvature of grooves, spheres and shafts â€“ even rivet geometry.
8th August 2019 • Read »
GTMA Manufacturing and Measurement 2016 show, 13th October at the Concord Centre in Sheffield
Spectrum Metrology will be demonstrating a range of surface finish, dimensional and flatness measurement systems at the forthcoming Manufacturing & Measurement show in Sheffield.
In particular, the Taylor Hobson Talyvel precision electronic level will be on show with it’s new, icon driven operating software giving a clean and user-friendly interface to the operator. Measurements are taken directly from the PC and error correction within the software allows higher accuracy and stabliity of results.
The Talyvel system is used extensively for the flatness calibration of granite or cast iron surface tables to international standards. The Talyvel 6 with the addition of the Electro Optics Analysis Software gives a fast and reliable method of calibration (click here for further details).
Also on show will be the Surtronic range of surface finish measurement instruments and also the Schneider VideoCAD Rapid 2D Geometry Measurement system, offering high definition dimensional measurement in a matter of seconds.
The Manufacturing & Measurement 2016 show is at the Concord Centre in Sheffield and guest speakers include Simon Gough-Rundle (Rolls-Royce) and Alan Olifent ( Jaguar Land-Rover Ltd).
For further details and free registration visit: http://www.makemeasurementmatter.co.uk/